Products

News Details

Home >> News >> Visual Inspection of

Visual Inspection of Roll Forming Machine

Release date:2014-08-01  stem:http://www.broswright.com/

The roll forming machine standard concerned with the qualification does not require such an extensive testing range for steels and the alloys in spite of high downspout roll forming machine price. The roll forming machine standard no longer requires hardness distribution tests for the cross section in terms of bend test and impact test since roll forming irons are characterized by using very high vibration roll forming machine. They do not undergo ultrasonic roll forming machine tests either, which is similar to the qualification of roll forming machine procedure for any other structural material.

At the same time, the roll forming machine visual inspection and liquid inspection should be carried out cover more than ninety percent of roll forming machine joints, irrespective of the metal group to which a given roll forming machine has been qualified to deal with. In addition, roll forming machine visual inspection should be conducted at every stage preceding the roll forming process so as to ensure excellent preparation and geometry of the final roll forming products. If roll forming machine visual inspection results are considered positive, the imperfections present in the roll forming machine test joint can be maintained within the limits specified for different quality levels.

Recommendations for roll forming machine metallic materials as well as the allowed imperfections should be well understood along with the cited standard. These are less restrictive with reference to the roll forming machine requirements concerning the same quality level in spite of high downspout roll forming machine price. Pursuant to standard roll forming machine test pieces should be sampled crosswise in relation to the joint and be circular in shape. For roll forming machine test piece that is less thick than fifty centimeters, it can be sampled from one plane, whereas in case of thicker joints, they should be taken from two roll forming machine planes.

To be more specific, they should be taken from the plane under the roll forming machine surface and from the one in the middle of a run or near the roll forming machine root. Frequent lack of precise information on roll forming machine metal mechanical properties implies the necessity of performing additional tensile tests so as to enable the determination of the minimum strength of the raw materials. The roll forming machine test piece for examination can be sampled from the test joint made of cast iron since the range of roll forming machine qualification covers the roll forming of all other grades. In case of malleable cast iron, a roll forming machine procedure test might be carried out for a selected grade of irons is valid for all grades in spite of high downspout roll forming machine price.

Related News

我要啦免费统计