Products

News Details

Home >> News >> Energy Saved in Roof

Energy Saved in Roof Panel Roll Forming Machine Maintenance

Release date:2014-07-21  stem:http://www.broswright.com/

The roll forming equipment products can be made of a slab by scrapping its surface after a series of heat treatment, hot rolling as well as cold rolling in roof panel roll forming machine maintenance. The roll forming products are cleaned at the edges via roll forming equipment or are welded and connected by the hot roll forming equipment. If the roll forming products can be made in a direct manner out of the melt, a lot of energy can be saved in roof panel roll forming machine maintenance. The roll forming equipment caster can cast the roll forming products directly from the molten metal so that roll casting is highly useful to save the energy in the fabrication of the clad roll forming products.

The development of the roll forming equipment as well as roll caster which can cast the clad roll forming products can be one of the best solutions to reduce the energy in production by large. However, there are only a few reports about the roll forming equipment products and there is no report about the roll casting of a three layer clad roll forming products in particular. The inventions of the roll forming equipment and roll caster, which can cast layers, feature an unequal diameter and a vertical tandem type that can be assembled. It may start from a lower large roll and two upper small roll forming equipment rolls. The roll forming equipment scraper is characteristic for this device and can be used to prevent a mixture from the different alloys.

The characteristic of the roll forming equipment vertical tandem type of the roll caster can be mounted on another vertical roll caster. Base roll forming products can be produced by the upper caster and the overlay roll forming equipment products can be cast by the lower one. Three layers clad roll forming equipment products can be cast by these roll casters so that the melting point can be higher than that of the overlay roll forming equipment products with different characteristics.

The process to cast clad roll forming equipment products by the conventional caster and the roll caster can be done within one process. It is clear that the roll casting of the clad roll forming equipment products has advantage of the process saving, which is also true in the case of modified types. Some kinds of roll forming equipment for clad roll forming products can be developed in this way so as to develop the roll caster which can cast three layers. The device has been designed, assembled and tested to produce better clad roll forming products under higher melting temperature in roof panel roll forming machine maintenance.

Related News

我要啦免费统计